Cisco Command Line -4

Cisco router interface up  command

Router>enable

Router>enable

Router#config

Router#configure ter

Router#configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#inter

Router(config)#interface fast

Router(config)#interface fastEthernet 0/0

Router(config-if)#no shut

Router(config-if)#no shutdown

Router(config-if)#

%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up

Router(config-if)#exit

Router(config)#exit

Router#

                                                                    Write By Arman